Applying Vinyl Siding Starter Strip

Measure a spot that is 1 1 2 inches above the bottom edge of the sheathing at this lowest point using a tape.

Applying vinyl siding starter strip.

Attach j channel trim strips around windows and doors and along the eaves. Locate the lowest possible corner that has sheathing. Nail the starter strip to the siding aligning the top of the strip with the chalk line. The bottom of the starter strip the part the bottom panel hooks on to should be at least.

Vinyl siding starter strips. Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house. Partly drive a nail 11 2 in. In order for the siding to be installed properly in a level fashion the starter strip at the bottom of the wall must be level.

This video shows how to install a starter strip for vinyl and polymer siding installation. Snap each length of siding in place so that its bottom lip hooks under the starter strip. Insert the flat hooked end of the zip tool under the lip on the bottom most edge of the vinyl siding panel that rests on top of the starter strip. Hold a tape measure against the exterior wall and travel.

From that point measure up 1 4 6 4mm less than the width of the starter strip and partially drive a nail at one corner. Insulation for vinyl siding 1. Determine the lowest point of the wall that will be sided. Position starter strip with the top edge of chalk line and allow room for corner posts.

Pull up as. Mice bees and all sorts of other critters love making their home inside vinyl corner posts. Staret strip secures the first course of siding to the home. Cap the corner posts.

Be sure to center the nails in their slots to. Pull the zip tool down while simultaneously. This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows. How to install a vinyl siding starter strip step 1.

13 simple vinyl siding installation tips use the wider starter strip. This is where the new siding will begin. Nail vertical vinyl corners to the corners of the house making sure they are plumb. Pop a level chalk line for the starter strip an inch or two above the bottom of the siding.